DOOR TECHNICAL DATA

American Door
Wing: 42 mm thick, the surface is 3.2 mm thick and wavy HDF American panel. Inside the air-hole filling of kraft honeycomb filler is used. Around the four sides of the wing 10-12% humidity resistant 35x45mm sized finger-joint fir boom has been returned. Reinforced boom is used to at the place of locks and hinges.

Case: 42 mm thick and 12 mm sized MDF top, middle and bottom 18 mm finger-joint masive panel is the 12 mm MDF. Case was given on the front of the wood texture pattern.

Molding: 10 mm in thickness, 70 mm wide, 2200 mm long is. The surface of the wood moldings Adjustable-pass is little changed.

Paint: Last cellulose paint finish on the two primer layer should be applied.

Furniture Door
Wing: 42 mm thickness. Upon request in accordance with ALPI coating is pressed on the 6 mm MDF. air-hole kraft honeycomb or hole ocal fiberboard is used as a internal filling. Serens located at the edges are 10-12% of water-resistant and 30x45mm sized fir serene with finger-joint.

Case: 42 mm thick and 12 mm MDF top, middle and bottom panel is baked and 18 mm thick , 12 mm MDF with respectively. Chassis front is covered by wing coating material.

Molding: 10 mm in thickness, 80 mm wide, 2200 mm long is. The surface of the sill-set switch is covered with a coating material.

Paint: The lacquer coating is applied on as natural pattern.

Laminate Door
Wing: Requested laminate coating is pressed on the 6mm MDF. Internal fillings are kraft honeycomb air holes or ocal fiberboard holes.Serens: 10-12% humidity resistant, 30x45mm sized finger-joint fir serene. PVC tape is coated to the wing edges.

Case: 42 mm thick and 12 mm MDF top, middle and bottom panel is baked 18 mm and12 mm MDF respectively. Front of the case according to the request will be covered with laminate or the appropriate color will be painted.

Molding: 10 mm in thickness, 80 mm wide, 2200 mm long is. The surface of the sill-set pass can be covered with laminate or the appropriate color paint.

Snowdrop Door
Wing: 42 mm thick, HDF-surface and it is pressed into flat or water-butt as a desired shape. Internal fillings are kraft honeycomb air holes or ocal fiberboard holes. 10-12% humidity resistant and edges are 30x45mm sized finger-joint fir serene.

Case: 42 mm thick and 12 mm MDF top, middle and bottom panel is baked 18 mm and 12 mm MDF respectively. Front of the case is patterned wood.

Molding: 10 mm in thickness, 70 mm wide, 2200 mm long is. The surface of the sill-pass moldings is wood patterned.